收藏本站
LT3497
OPERATION
Main Control Loop
The LT3497 uses a constant frequency, current mode con-
trol scheme to provide excellent line and load regulation.
It incorporates two identical, but fully independent PWM
converters. Operation can be best understood by referring
to the Block Diagram in Figure 1. The oscillator, start-up
bias and the band gap reference are shared between the two
converters. The control circuitry, power switch, Schottky
diode etc., are identical for both the converters.
At power up, the capacitors at CAP1 and CAP2 pins are
charged up to V IN (input supply voltage) via their respective
inductor and the internal Schottky diode. If either CTRL1
and CTRL2 or both are pulled higher than 100mV, the
bandgap reference, the start-up bias and the oscillator
are turned on.
The main control loop can be understood by following the
operation of converter 1. At the start of each oscillator cycle,
the power switch, Q1, is turned on. A voltage proportional
to the switch current is added to a stabilizing ramp and the
resulting sum is fed into the positive terminal of the PWM
comparator, A2. When this voltage exceeds the level at the
negative input of A2, the PWM logic turns off the power
switch. The level at the negative input of A2 is set by the
error ampli?er, A1, and is simply an ampli?ed version of
the difference between the V CAP1 and V LED1 voltage and
the bandgap reference. In this manner the error ampli?er,
I L
50mA/DIV
V SW
10V/DIV
A1, sets the correct peak current level in inductor L1 to
keep the output in regulation. The CTRL1 pin is used to
adjust the LED current.
If only one of the converters is turned on, the other converter
will stay off and its output will remain charged up to V IN
(input supply voltage). The LT3497 enters into shutdown
when both CTRL1 and CTRL2 pins are pulled lower than
50mV. The CTRL1 and CTRL2 pins perform independent
dimming and shutdown control for the two converters.
Minimum Output Current
The LT3497 can drive a 4-LED string at 2mA LED current
without pulse skipping. As current is further reduced, the
device may begin skipping pulses.
This will result in some low frequency ripple, although the
average LED current remains regulated down to zero. The
photo in Figure 2 details circuit operation driving 4 white
LEDs at 2mA. Peak inductor current is less than 50mA and
the regulator operates in discontinuous mode, meaning
the inductor current reaches zero during the discharge
phase. After the inductor current reaches zero, the SW
pin exhibits ringing due to the LC tank circuit formed
by the inductor in combination with the switch and the
diode capacitance. This ringing is not harmful; far less
spectral energy is contained in the ringing than in the
switch transitions.
V IN = 4.2V
200ns/DIV
3497 F02
I LED = 2mA
4 LEDs
Figure 2. Switching Waveforms
3497f
8
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LT3498EDDB#TRPBF IC LED DRVR WT/OLED BCKLGT 12DFN
LT3517HUF#PBF IC LED DRIVER AUTOMOTIVE 16-QFN
LT3519EMS-2#PBF IC LED DRVR HP CONST CURR 16MSOP
LT3590ESC8#TRMPBF IC LED DRVR WHITE BCKLGT SC-70-8
LT3591EDDB#TRMPBF IC LED DRIVER WHITE BCKLGT 8-DFN
LT3593ES6#TRMPBF IC LED DRIVR WHITE BCKLGT TSOT-6
LT3595AEUHH#TRPBF IC LED DRIVR WHITE BCKLGT 56-QFN
LT3595EUHH#TRPBF IC LED DRIVR WHITE BCKLGT 56-QFN
相关代理商/技术参数
LT3497EDDB#TRPBF 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3498 制造商:LINER 制造商全称:Linear Technology 功能描述:20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN
LT3498EDDB 制造商:LINER 制造商全称:Linear Technology 功能描述:20mA LED Driver and OLED Driver with Integrated Schottky in 3mm x 2mm DFN
LT3498EDDB#TRMPBF 功能描述:IC LED DRVR WT/OLED BCKLGT 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3498EDDB#TRPBF 功能描述:IC LED DRVR WT/OLED BCKLGT 12DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT34-SC 制造商:THOMAS & BETTS 功能描述:
LT3500 制造商:World Products 功能描述:
LT3500EDD#PBF 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*